Turn On The Pdm; The Setup Wizard - OmniPod CAT45E Guide De L'utilisateur

2
Getting Started
Chapter 6 describes the PDM options in detail. The instructions in
this chapter are simplified to help you get started.

Turn on the PDM

1. Open the battery compartment on the back of the PDM
by pushing the compartment latch and lifting upward
(Figure 2-1). No special tools are necessary.
Figure 2-1
10
Figure 2-2
Hard
Reset
2. Insert two (2) new AAA alkaline batteries into the
compartment.
The diagram inside the compartment shows you which
direction to insert the batteries (Figure 2-2).
Do not use any other type of batteries than AAA
alkaline batteries to power the PDM. Never use old or
used batteries; the PDM may not work properly.
3. Replace the battery door.
4. Turn the PDM face up. The PDM has begun to power on
auto matically.

The Setup Wizard

n
The first time you turn on the Personal Diabetes Manager, the
Setup Wizard comes on automatically. Although setup is easy
with the Wizard, if you are a first-time user, your healthcare
pro vider must guide you through the process. Setup takes only a
few minutes and is easy to do:
• Use the Up/Down Controller buttons to increase or decrease
a number, or to move up or down a list.
Initial settings are "---" [blank] for target blood glucose
value, insulin-to-carbohydrate ratio, correction factor,
and duration of insulin action.