Entering Blood Glucose Readings Manually; Editing Tags - OmniPod CAT45E Guide De L'utilisateur

Figure 7-33
The Bolus Entry screen does not open if:
• A regular bolus is currently in process
• The meter temperature is out of range
• You have tagged this BG reading as a Control
• The BG reading is less than your "Min BG for calcs"
• Insulin is suspended

Entering Blood Glucose Readings Manually

n
You can enter blood glucose readings manually into the PDM.
This is particularly helpful if you use a separate blood glucose
meter.
Checking Your Blood Glucose
1. On the Home screen, use the Up/Down Controller buttons
to choose More actions, then press Select.
2. Choose Add BG reading, then press Select.
3. Use the Up/Down Controller buttons to enter the BG
reading from your separate meter.
To enter a "LOW" reading, press the Up/Down
Controller buttons down until you reach the
minimum value (1.1); then press down one more
time. To enter a "HIGH" reading, press up until you
reach the maximum value (27.8); then press up
one more time.
4. Press Tag to assign a tag to the reading. Press OK when
finished. (For an explanation of entering tags, see page 93.)
5. Press Save to save the reading.
Or press Cancel to return to the More actions menu without
saving the reading.

Editing Tags

n
Within 2 hours of a blood glucose reading, you can remove or
change a tag or add one. However, you cannot alter a Control tag.
1. On the Home screen, use the Up/Down Controller buttons
to choose More actions, then press Select.
2. Choose Assign/Edit BG tags, then press Select.
7
95