EUROM RK2009T Manuel D'utilisation page 29

Screw the 2 x 2 swivel castors (3) with the 4 capped nuts (2) onto the ends of

the two wheel supports (1). The wheels should be at the hollow side!
Turn the radiator upside-down (make sure you don't scratch the paint or the

floor!)
Attach the two supports (each with 2 swivel castors) to the radiator. Slide the

U-shaped bolts onto both sides between the outer fins of the radiator, the end
the screw thread and the outwards facing curve.
First slide the supports (with the swivel castors) over the curve and then over

the end of the screw thread.
Please note: the wheels should be placed as far away from one another
as possible!
Return the heater to its upright position, wheels down.

Select a suitable location for the device taking into account all the

aforementioned warnings in this manual.
Warning: only use the heater when it is in an upright position, with the
wheels attached to the bottom (as pictured on the front of this manual).
Any other position is dangerous!
Set-up and Operation
Set the power switches to off (underside not depressed) and the thermostat dial

to HIGH (maximum).
Plug in the heater.

In order to switch on the heater, set one or both power switches to l.c.q. II. The

light(s) on the related switch(es) turn(s) on and the heater starts to function.
For slow heating, a small rise in temperature or a small space, choose setting I
(800W). For quick heating, a bigger temperature rise or a larger space, choose
setting II (1200W). I and II together give full power (2000W).
Once the space has reached the right temperature, turn the thermostat dial to

LOW until you hear a click. If you leave the dial in this position, the heater will
29