Agilent Technologies TwisTorr 74FS AG Rack Mode D'emploi page 224

17 Technical Information
Programmable Analog Output Diagrams
Pump Connector
The controller is equipped with a 5 meter long cable. The
following figure shows the controller output connector
configuration where pins:



Figure 22
J5 – Gauge Connector
This connector is available to connect the Agilent active gauges.
The controller recognizes automatically the gauge connected by
reading the signal "identification" in the connector.
Following table shows all supported gauges:
Gauge model
FRG 700/702
IMG 500
PVG 500/502
IM 500
CDG 500 T1000
CDG 500 T0100
CDG 500 T0010
CDG 500 T0001
224/300
A-F = pump temperature sensor
B-C-D = 76 V AC 3-phase output to pump motor stator
E = EARTH PROTECTION
Controller-to-Pump Connector
Name showed in the display
FRGa
IMG
PVGa
IM
CDG3
CDG2
CDG1
CDG0
TwisTorr 74 FS AG Rack Controller User Manual / 87-901-055-01