Agilent Technologies TwisTorr 74FS AG Rack Mode D'emploi page 267

ANALOG OUT TYPE: permits selection of the type of signal

START OUT MODE: Selects the operating mode of the

SPEED OUT MODE (KRPM/Hz): permits selection of the

LCD CONTRAST: selectable from 0 to 7.

TwisTorr 74FS AG Rack Controller User Manual / 87-901-055-01
to be sent to the programmable analogue output. One of the
following signals can be selected:
FREQUENCY: the drive frequency of the pump is shown

POWER: the power supplied to the pump is shown

TEMPERATURE: the temperature of the pump is shown

PRESSURE: the pressure read by the gauge is shown.

START output. Possible options:
RUNNING: the output is active when the pump is driven

STARTING: the output is active only during acceleration

ramp-up.
unit of measurement of the speed of rotation shown on the
display of the controller.
This setting acts only on the measurement shown on the
display. Possible options:
KRPM

Hz

Technical Information
Programming
267/300
17