Part Description - Birchmeier REC 15 Série Mode D'emploi

2. Part description

Filling cap
The membrane ventilates the air inside the spray tank, thereby preventing the contraction of the tank and
ensuring permanent suction of the spray mixture.
The O-ring prevents spillage of the spray mixture.
Filling filter
Always filter the spray agent through the filling filter into the tank. This protects the pump from foreign object
damage.
Spray tube support
The spray tube can be placed in the nozzle mount underneath, and clamped above in the gap between the
retaining ring to prevent the nozzle from contamination.
The adjustable pistol valve Vario Gun can be hooked into the rectangular notch when needed (see fittings on
page 42).
Spray tank
Robust, ergonomical plastic container with a 15 litre (4 US gallons) capacity.
Adjustable carrying belt
To shorten the shoulder straps, pull on the protruding straps of the belt, and to lengthen, move the buckles
up.
Click belt
Allows you to easily put on and take off the appliance. On one side fasten the belt, put the appliance on, and
comfortably click together with the second buckle.
Potentiometer, On/Off button
One turn to the right = appliance is switched on.
The pressure can be continuously adjusted from 0.5 – 6 bar.
LED display
Whilst the appliance is running the LED display provides information about the battery's current state of
charge. Green: State of charge > 50 %, yellow: State of charge 30 – 50 %, red: State of charge < 30 %. In the
event of failure, an error code will be displayed (see page 27).
Hose
Its length of 1.3 m (4.27 ft) enables maximum freedom of movement.
Trigger
Robust plastic valve with an integrated filter and screwed in spray tube connection. This enables the use of
our entire range of Birchmeier screw fittings (see page 42 and www.birchmeier.com).
Spray tube
Curved 50 cm (1.64 ft) long brass spray tube. You can find more spray tubes in the fittings section on page
42, and on www.birchmeier.com
Adjustable nozzle
The spray pattern and flow can be adjusted by turning the nozzle head in the following ways.
Spray sparingly (Close nozzle), misty (Open nozzle, ½ a turn) and for a jet stream (Open nozzle, turn 3 times)
For flow rates, please refer to the table on page 27.
Air vessel
The air vessel smooths out the pressure surges during the spraying.
Pump and motor
The electronically controlled piston pump controls the motor speed in accordance to the output required
(pressure and flow). In this way the battery is saved for a large part of the time, and you can use the
appliance for longer. Information about the period of application can be found in the table on page 27.
Battery
Depending on the model, the appliance is available to use with the easy-to-replace AGM battery or a quick-
change Li-ion battery.
The Li-ion battery automatically reverts to sleep mode when it is not used for a long period of time, in order to
avoid a full self-discharge. The battery will be reactivated by taking out the battery and reinserting it.
- 15 -