Publicité
Les langues disponibles
Les langues disponibles
Safety instructions motor, pump; Description of Motor, Sound intensity level
Clean the pump after each operation.
Never store the pump in areas in which corrosive
vapours exist.
Do not remove the motor from the pump as long
as there is any back pressure.
With pressurised containers, the motor must only be taken off
when the container is depressurised.
Before removing the motor from the pump:
Completely drain pump, flexible hose and hand nozzle.
Power supply must include a fault current breaker.
Dirt accumulation, high humidity or material damage on
the motor housing may lead to dangerous current surges.
In case of breakage or obvious damage of the housing
immediately stop the pump and repair it.
Non-compliance with the safety instructions may cause
injuries to the operator, pollution of the environment or
damage to the motor and the pump.
Description of motor
Internally cooled commutator motor with overload cut-out switch
and no-volt release
Power: 800 Watt
Overload cut-out switch
If the maximum current is exceeded, the motor switches off. After
cooling down, the motor can be restarted by pressing the on/off
button.
No-volt release
The motor is secured against accidental start-up following
interruption of the operating voltage (see rating plate: U<).
The motor cannot be remote-controlled. The motor can only
be restarted by pressing the on/off button.
Sound intensity level
The sound intensity level of this pump is = 74 dB (A)
(measured on the manufacturer's pump test stand)
13
Publicité
