Dmx-Protocol; Cleaning And Maintenance - EuroLite TR-5 Mode D'emploi

DMX-protocol

Control channel 1 - Gobo-wheel, gobo-shake
DMX-Value Feature
0-5 Blackout
6-39 Strobe-effect
40-45 Open
46-51 Gobo 1
52-57 Gobo 2
58-63 Gobo 3
64-69 Gobo 4
70-75 Gobo 5
76-81 Gobo 6
82-87 Gobo 7
88-93 Gobo 8
94-99 Gobo 9
100-105 Gobo 10
106-111 Gobo 11
112-117 Gobo 12
118-123 Gobo 13
124-129 Open
130-135 Gobo 1 shake with increasing speed
136-141 Gobo 2 shake with increasing speed
142-147 Gobo 3 shake with increasing speed
148-153 Gobo 4 shake with increasing speed
154-159 Gobo 5 shake with increasing speed
160-165 Gobo 6 shake with increasing speed
166-172 Gobo 7 shake with increasing speed
173-177 Gobo 8 shake with increasing speed
178-183 Gobo 9 shake with increasing speed
184-189 Gobo 10 shake with increasing speed
190-195 Gobo 11 shake with increasing speed
196-201 Gobo 12 shake with increasing speed
202-207 Gobo 13 shake with increasing speed
208-225 Stop
226-255 Cont. gobo-wheel rotation with increasing speed
Control channel 2 – Flower Rotation
DMX-Value Feature
0-26 Stop
27-130 Red with increasing speed
131-149 Stop
150-255 Red with decreasing speed

CLEANING AND MAINTENANCE

The operator has to make sure that safety-relating and machine-technical installations are inspected by an
expert after every four years in the course of an acceptance test.
The operator has to make sure that safety-relating and machine-technical installations are inspected by a
skilled person once a year.
The following points have to be considered during the inspection:
1) All screws used for installing the devices or parts of the device have to be tighly connected and must not
be corroded.
27/55 51785863_V_1_0.DOC