Dmx-Protocol - EuroLite TG-5 Mode D'emploi

For address setting, press the Up/Down-buttons until the display shows "A001" and set the desired address
via the Up/Down-buttons.
Controlling:
After having addressed all TG-5, you may now start operating these via your lighting controller.
Note:
After switching on, the TG-5 will automatically detect whether DMX 512 data is received or not. If the data is
received, the control LED flashes. If there is no data received at the DMX-input, the control LED lights up
permanently.
This situation can occur if:
- the 3 PIN XLR plug (cable with DMX signal from controller) is not connected with the input of the TG-5.
- the controller is switched off or defective, if the cable or connector is defective or the signal wires are swap
in the input connector.
Note:
It's necessary to insert the XLR termination plug (with 120 Ohm) in the last lighting in the link in order to
ensure proper transmission on the DMX data link.

DMX-protocol

Control channel 1 - Colour-wheel
Linear colour change following the movement of the slider. In this way you can stop the colour-wheel in any
position.
DMX-value Feature
0-9 White
10-20 Green
21-31 Red
32-41 Cyan
42-52 Bright green
53-63 Rose
64-73 Bright blue
74-84 Yellow
85-95 Green
96-105 Pink
106-116 Purple
117-128 Orange
129-190 Scroll
191-193 Sound-controlled
194-223 Forwards rainbow effect with decreasing speed
224-225 No rotation
226-255 Backwards rainbow effect with increasing speed
Control channel 2 - Gobo-wheel, gobo-shake
DMX-value Feature
0-5 Blackout
6-31 Strobe-effect
32-41 Open
42-52 Gobo 1
53-63 Gobo 2
64-73 Gobo 3
74-84 Gobo 4
85-95 Gobo 5
96-105 Gobo 6
106-116 Gobo 7
117-127 Gobo 8
128-137 Gobo 9
138-147 No function
148-155 Gobo 1 shake with increasing speed
24/51 51785850X88NXS_V_1_0.DOC