Dmx-Controlled Operation; Addressing; Dmx-Protocol - EuroLite LED QMS-8 RGB Mode D'emploi

2. Music Controlled Operation
Select che9 and adjust the audio input level using the sensitivity control dial on the side panel of the
controller.

DMX-controlled operation

You can control the devices individually via your DMX-controller.

Addressing

The Control Board allows you to assign the DMX fixture address, which is defined as the first channel from
which the LED QMS-8 RGB will respond to the controller.
For address setting, press the Up/Down-buttons until the display shows "A001" and set the desired address
via the Up/Down-buttons.
Controlling:
After having addressed the LED QMS-8 RGB, you may now start operating it via your lighting controller.
Note:
After switching on, the LED QMS-8 RGB will automatically detect whether DMX 512 data is received or not.
If the data is received, the control LED flashes. If there is no data received at the DMX-input, the control LED
lights up permanently.
This situation can occur if:
- the 3 PIN XLR plug (cable with DMX signal from controller) is not connected with the input of the LED
QMS-8 RGB.
- the controller is switched off or defective, if the cable or connector is defective or the signal wires are swap
in the input connector.
Note:
It's necessary to insert the XLR termination plug (with 120 Ohm) in the last lighting in the link in order to
ensure proper transmission on the DMX data link.

DMX-protocol

L I
Control channel 1 – Each device occupies 12 channels. Four devices occupy 48 channels.
L2
Control channel 2 – Each device occupies 6 channels. Four devices occupy 24 channels.
CH CH CH
1-12 13-24 25-36
CH CH CH
1-6 7-12 13-18
19/39
CH
37-48
CH
19-24
51930260_V_1_1.DOC