Operation; Stand Alone Operation; Dmx-Controlled Operation; Dmx-Protocol - EuroLite TC-150 Mode D'emploi

OPERATION

After you connected the effect to the mains, the TC-150 starts running. During the Reset, the motors are
trimmed and the device is ready for use within approximately 20 seconds.
Turn the objective-lens for adjusting the focus in order to obtain a sharp projection.

Stand Alone operation

In the Stand Alone mode, the TC-150 can be used without controller. You can do without a controller as the
TC-150 features a built-in microphone, which provides automatic sound control.
Disconnect the TC-150 from the controller and set all DIP-switches to Off.
The lamp is automatically ignited as soon as the condensor microphone receives music signals.
Call up the internal program
In order to call up the internal program, set DIP-switches No. 9 and 10 to On.
Master/Slave-operation
Connect the master and slave-devices as desribed above and set the DIP-switches accordingly.
Please note: If you wish to change from one operating mode into another, you either have to switch off the
lamp/activate Blackout-mode or unplug the projector from the mains and plug it again.

DMX-controlled operation

You can control the projectors individually via your DMX-controller. Every DMX-channel has a different
occupation with different features.

DMX-protocol

Control channel 1 - Colour-wheel
DMX-value Feature
0-17 Open/white 144-161
18-35 Red
36-53 Yellow
54-71 Violet
72-89 Green
90-107 Orange
108-125 Blue
126-143 Pink
Control channel 2 - Gobo-wheel
DMX-value Feature
0-17 Open
18-35 Gobo 1
36-53 Gobo 2
54-71 Gobo 3
72-89 Gobo 4
90-107 Gobo 5
108-125 Gobo 6
126-143 Gobo 7
DMX-value Feature
Light green
162-179 Light blue
180-197 Orange/yellow
198-215 Light yellow
216-233 Magenta
234-251 Color mixing (red with blue)
252-255 Color mixing (yellow with green)
DMX-value Feature
144-161 Gobo 8
162-179 Gobo 9
180-197 Gobo 10
198-215 Gobo 11
216-233 Gobo 12
234-251 Gobo 13
252-255 Gobo 14
26/52 00026408.DOC, Version 1.3