Stand Alone Operation; Dmx-Controlled Operation; Addressing; Dmx-Protocol - EuroLite TS-5 Mode D'emploi

Stand Alone operation

In the Stand Alone mode, the TS-5 can be used without controller. You can do without a controller as the TS-
5 features a built-in microphone, which provides automatic sound control.
Disconnect the TS-5 from the controller and select "Sound-controlled Program-Run" (F4 – yes) or "Program-
Run" (F5 – yes).
Master/Slave-operation
Connect the master and slave-devices and adjust the settings as described above.
Please note: If you wish to change from one operating mode into another, you have to disconnect the
projector from the mains and connect it again.

DMX-controlled operation

You can control the projectors individually via your DMX-controller. Every DMX-channel has a different
occupation with different features. In order to call up the different features, you first have to open the dimmer
(control channel 5, DMX-value 255). Furthermore, all other programs must be set on -n- (off).

Addressing

The Control Board allows you to assign the DMX fixture address, which is defined as the first channel from
which the TS-5 will respond to the controller.
If you set, for example, the address to channel 6, the TS-5 will use the channel 6 to 10 for control.
Please, be sure that you don't have any overlapping channels in order to control each TS-5 correctly and
independently from any other fixture on the DMX data link.
If two, three or more TS-5 are addressed similarly, they will work similarly.
For address setting, press the UP/DOWN-buttons until the display shows "A001" and set the desired address
via the YES/NO-buttons. Press the ENTER button to confirm.
Controlling:
After having addressed all TS-5, you may now start operating these via your lighting controller.
Note:
After switching on, the TS-5 will automatically detect whether DMX 512 data is received or not. If the data is
received, the control LED flashes. If there is no data received at the DMX-input, the control LED lights up
permanently.
This situation can occur if:
- the 3 PIN XLR plug (cable with DMX signal from controller) is not connected with the input of the TS-5.
- the controller is switched off or defective, if the cable or connector is defective or the signal wires are swap
in the input connector.
Note:
It's necessary to insert the XLR termination plug (with 120 Ohm) in the last lighting in the link in order to
ensure proper transmission on the DMX data link.

DMX-protocol

Control channel 1 - Horizontal movement (Pan)
Push slider up in order to move the mirror horizontally (PAN).
Gradual mirror adjustment from one end of the slider to the other (0-255, 128-center). The mirror can be
stopped at any position you wish.
DMX-value Feature
0-255 Gradual adjustment of the mirror position from left to right
Control channel 2 - Vertical movement (Tilt)
Push slider up in order to move the mirror vertically (TILT).
Gradual mirror adjustment from one end of the slider to the other (0-255, 128-center). The mirror can be
stopped at any position you wish.
DMX-value Feature
0-255 Gradual adjustment of the mirror position from down to up
27/57 00026361.DOC, Version 1.3