Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
DMX-protocol
Channel 1
Red
0 - 255
0-100 %
Channel 2
Green
0 - 255
0-100 %
Channel 3
Blue
0 - 255
0-100 %
Channel 4
Dimmer
0 – 255
0-100 %
Channel 5
Flash
0 - 10
No function
11 - 255
0-100 % with increasing speed
Blackout
In order to select Blackout, set DIP switch 10 to ON and DIP switch 1 to 9 to OFF.
CLEANING AND MAINTENANCE
The operator has to make sure that safety-relating and machine-technical installations are inspected by an
expert after every four years in the course of an acceptance test.
The operator has to make sure that safety-relating and machine-technical installations are inspected by a
skilled person once a year.
The following points have to be considered during the inspection:
1) All screws used for installing the devices or parts of the device have to be tightly connected and must not
be corroded.
2) There must not be any deformations on housings, fixations and installation spots (ceiling, suspension,
trussing).
3) The electric power supply cables must not show any damages, material fatigue (e.g. porous cables) or
sediments. Further instructions depending on the installation spot and usage have to be adhered by a
skilled installer and any safety problems have to be removed.
We recommend a frequent cleaning of the device. Please use a soft lint-free and moistened cloth. Never use
alcohol or solvents!
There are no serviceable parts inside the device except for the fuse. Maintenance and service operations are
only to be carried out by authorized dealers.
DANGER TO LIFE!
Disconnect from mains before starting maintenance operation!
20/40
00024228.DOC, Version 1.2
Publicité
Table des Matières
