Preparing The Mower For Long-Term Storage - EINHELL Royal BM 40 K Instructions De Montage Et Mode D'emploi

Anleitung BM 40_K-BM 46_K_SPK1:_
12.4. Checking the oil level
Important: Never run the engine with no or too little
oil. This could cause severe damage to the engine.
Use only 15W40 engine oil.
Checking the oil level:
Stand the lawn mower on a flat level surface.
Unscrew the oil dip stick by turning anticlockwise,
pull out and wipe. Insert the dip stick back in the
filling mount as far as the stop, but do not screw back
in. Pull out the dip stick again and read off the oil
level while holding horizontally. The oil level must be
between the maximum (H) and the minimum (L, Fig.
17). The moveable orange plastic part on the oil dip
stick provides protection against oil foam.
Changing the oil
Change the engine oil every year before the start of
the season (in addition to the information in the
petrol service manual) when the engine is warm.
Use only engine oil (15W40).
Place the mower on a work table with the right-
hand front wheel (in the pushing direction)
projecting free of the table.
Place a flat oil drip tray beneath the mower.
Open the oil filler screw (Fig. 16/Item A).
Open the oil drainage screw (Fig. 18). Drain the
warm engine oil into a drip tray.
Close the drain screw again when all the used oil
has been drained.
Fill up with engine oil as far as the top mark on the
dipstick.
Important! Do not screw in the oil dipstick to check
the oil level – only insert it as far as the thread.
Dispose of the used oil in accordance with
applicable regulations.
12.5 Care and adjustment of the cables
Oil the cables at regular intervals and check that they
move easily.
Check the adjustment of the cables every time
before you use the machine.
12.5.1 Adjusting the cord for the engine brake
If you notice a drop in the performance of the
engine brake, the cord (Fig. 19/Item A) will need
readjusting.
12.6 Maintenance of the air filter (Fig. 23-24)
A soiled air filter will reduce the performance of the
engine because it will prevent enough air getting to
the carburetor. It is therefore imperative that regular
checks are made. The air filter should be checked
every 25 hours and cleaned if required. If the air is
26.09.2007 8:14 Uhr Seite 23
very dusty the air filter should be checked more
regularly.
Important: Never clean the air filter with petrol or
inflammable cleaning agents (Fig. S). Clean the air
filter with compressed air or simply by knocking out
any soiling.
12.7 Maintenance of the spark plug
Check the spark plug for dirt and grime after 10
hours of operation and if necessary clean it with a
copper wire brush. Thereafter service the spark
plug after every 50 hours of operation.
Pull off the spark plug boot (Fig. 25) with a twist.
Remove the spark plug (Fig. 26) with the supplied
spark plug wrench.
Assemble in reverse order.
12.8 Repairs
After any repair or maintenance work, check that all
safety-related parts are in place and in proper
working order.
All parts which may cause injury must be kept where
they are inaccessible to children or others.
Important: In accordance with product liability
legislation we are not liable for any damages caused
by improper repairs or the use of spare parts that are
not original spare parts or parts approved by us. In
addition, we are also not liable for any damages
arising from improper repairs. Such work should be
performed by a customer services workshop or
authorized specialist. The same applies to accessory
parts.
12.9 Times of use
Lawn mowers are only permitted to be used on
workdays between the hours of 7.00 a.m. and 7.00
p.m. Please comply with statutory regulations, which
may vary from location to location.
13. Preparing the mower for long-term
storage
Caution: Do not empty the petrol tank in enclosed
areas, near fire or when smoking. Petrol fumes can
cause explosions and fire.
1. Empty the petrol tank with a petrol suction pump.
2. Start the engine and let it run until any remaining
petrol has been used up.
3. Change the oil at the end of every season. To do
so, remove the used engine oil from a warm
engine and refill with fresh oil.
4. Remove the spark plug from the cylinder head.
Fill the cylinder with approx. 20 ml of oil from an
oil can. Slowly pull back the starter handle, which
GB
23