MIRKA DEOS Mode D'emploi page 49

Troubleshooting guide
Symptom
The sander LED (right) is flashing
between red and green.
No light from sander LED (right) when
switched on.
The sander LED (right) is red and the
sander slows down to 5,000 rpm when
sanding.
The sander LED (right) is red and rpm is
slightly reduced.
The sander has stopped and LED (right)
is red.
Disposal information
DANGER
Disposal guidelines for old appliances Render redundant power tools unusable by removing the
power cord Only for EU countries Do not dispose of electric tools along with household waste
According to European Directives 2002/95/EC, 2012/19/EU + 2003/108/EC on waste electrical and
electronic equipment and their implementation under national law, electric tools that have reached
the end of their life must be collected separately and taken to an environmentally compatible
recycling facility
Possible cause
Connected to a mains outlet with wrong
voltage
Power cord not properly attached to the
sander or to the mains socket
Temperature too high in the sander Too
heavy long-term load
Too heavy short-term load
The tool is in safety mode due to high
temperature
Mirka® DEOS 353 & 383 • 81 x 133 mm (3 x 5") & 70 x 198 mm (3 x 8")
Solution
Connect the sander to a mains outlet that
matches the nominal voltage of the tool
Connect it properly
Reduce the load on the sander for some
time and the sander will speed up again
Use lighter load and the LED (right) will
automatically change to green
Wait until the tool has cooled down
en
49