MIRKA DEOS Mode D'emploi page 48

en
Maintenance
Always disconnect the power before maintenance!
Only use original Mirka spare parts!
Replacing the backing pad
The backing pad is fixed with 8 screws
A = 8 mm (only on 70 x 198 mm)
B = 16 mm
Remove
1 Turn the tool upside down
2 Remove the 4 screws (A)
3 Remove the 4 screws (B)
4 Remove the backing pad
Install
1 Fit the new pad
2 Fit the 4 screws (B)
3 Fit the 4 screws (A)
4 Finally tighten all 8 screws
Pad saver
Mirka's pad savers are designed to protect the backing pad from wear and tear, when sanding aggressively and
continuously with net products These cost-effective pad savers, placed between the backing pad and the sanding
strip, should be changed regularly The pad savers prolong the life of the backing pad
http://www mirka com/accessories/Pad_Savers/
Further service
Servicing must always be performed by trained personnel To keep the tool warranty valid and ensure optimal tool
safety and function, servicing must be carried out by a Mirka authorized service center To locate your local Mirka
authorized service center, contact Mirka Customer service or your Mirka dealer
48
Mirka® DEOS 353 & 383 • 81 x 133 mm (3 x 5") & 70 x 198 mm (3 x 8")
A
B
A
B
B
A
B
A