Stiebel Eltron EBK 5 K Utilisation Et Installation page 20

INSTALLATION
Installation
45
f Using the installation template, transfer the dimensions of f
the wall mounting to the wall. To do so, loosely screw the in-
stallation template with tap connection to the wall.
f Drill the holes. f
EBK 5 K
1 2
1 Twin connector with throttle screw
2 Plastic sleeve
3 White-coated two-handled lever tap
f Screw in the twin connector. f
f Slide the plastic sleeve onto the twin connector. f
105
+15
1 Screw depth specification
2 White-coated two-handled lever tap with throttle screw
f Screw in the tap, taking care to observe the screw depth f
specification.
f Attach the tap outlet. f
KBA 5 KA
105
+15
3
1 Screw depth specification
2 Chrome-coated three-handled tap with throttle screw
3 Extensions
f Screw in the tap with the extensions, taking care to observe f
the screw depth specification.
f Attach the tap outlet. f
20 | EBK | KBA
3
1
2
1
2
EBK 5 K
12 + x
22 + x
2
105 + x
KBA 5 KA
12 + x
22 + x
2
105 + x
1 Wall mounting bracket
2 Height specification
x Increase of tap insertion depth / distance of tabs from the
wall mounting bracket: maximum 15 mm.
Note
If the tap insertion depth is greater than
105 mm, adapt the bend in the tabs of the wall mounting
bracket (see illustration).
f Fit the wall mounting bracket using the rawl plugs, washers f
and screws supplied.
f Align the wall mounting bracket using a spirit level. Take f
care to observe the height specification. If the wall is uneven,
the wall mounting bracket can be secured using additional
screws at the bottom.
1
1
www.stiebel-eltron.com