PRESIDENT TOMMY ASC Manuel D'utilisation page 32

a) ASC: AUTOMATIC SQUELCH CONTROL
Worldwide patent, a PRESIDENT exclusivity.
Turn the SQ knob (3) anti-clockwise into ASC position. «ASC» appears on the display. No
repetitive manual adjustment and a permanent improvement between the sensitivity
and the listening comfort when ASC is active. This function can be disconnected by
turning the switch clockwise. In this case the squelch adjustment becomes manual
again. «ASC» disappears from the display.
b) MANUAL SQUELCH
Turn the SQ knob clockwise to the exact point where all background noise disappears.
This adjustment should be done with precision as, if set to maximum (fully clockwise),
only the strongest signals will be received.
4) CHANNEL SELECTOR: Rotary Knob
This button allow increasing or decreasing a channel. A «beep» sounds each time
the channel changes if the KEY BP function is activated. See KEY BP function.
5) F ~ KEY BP
F - FREQUENCY BAND SELECTION
(configuration: E; d; EU; PL)
The frequency bands have to be chosen according to the country of use. Don't use
any other configuration. Some countries need a user's licence.
See table page 51.
Proceeding: switch off the transceiver. Keep the key F pressed and switch on again.
and the letter corresponding to the configuration are blinking.
- In order to change the configuration, use the channel selector on the front panel.
- When the configuration is selected, press 1 second on the F key.
corresponding to the configuration are continuously displayed, a beep sounds. At
this point, confirm the selection by switching off the transceiver and then switching
it on again.
See the configurations / frequency bands table pages 48 to 50.
KEY BP
Beep on changing the channel, keys etc... (long press)
Activate the KEY BP function by pressing 1 second the KEY BP key. A beep sounds
and «BP» is displayed. In order to disable the function, press during 1 second the KEY
BP key. «BP» disappears.
6) LOCK
Allows to lock all the keys on the front panel and the rotary knob. An error beep
sounds when a key is used and the LOCK function is activated. A short press on
LOCK activates/deactivates the LOCK function.
the function is activated.
Transmission and reception remain active.
7) 6 PIN MICROPHONE PLUG
The plug is located on the front panel of the transceiver and makes the setting of
the equipment into the dashboard easier.
See cabling diagram page 49.
8) PTT
Transmission key, press to transmit a message,
to an incoming communication.
and the letter
32
appears on the display when
is displayed and release to listen