Setting Up; Before Taking Into Use; Operation; Adjusting The Browning Level - SilverCrest STS 850 A1 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 52
To avoid an overheating of the toaster and to obtain an even browning
of bread, wait for about 15 seconds between two toasting processes.
You should only use the highest level on the toasting dial 1 for large slices
of dark bread. With this browning level light bread will scorch and become
inedible. In addition, it may cause the generation of smoke. If this occurs,
press the button "Stop"
from the mains power socket.

Setting up

CAUTION – RISK OF FIRE
You should therefore NEVER locate the appliance close to or underneath
infl ammable objects, especially not under curtains or suspended cupboards.
Unwind the cable completely from around the cable winder 8 and lead it
through the cable clamp 2.
Place the appliance on a level and heat-resistant surface.
Insert the plug into a mains power socket.

Before taking into use

Operate the toaster without bread for 5 times at the maximum browning
level "7".
Afterwards, clean the toaster as described in the chapter "Cleaning".
NOTICE
The operating slide 7 only engages when the cable is connected to a
mains power socket.
With the fi rst usage a slight smell can arise (minimal smoke development is
also possible). This is normal and dissipates after a short time. Provide for
suffi cient ventilation. For example, open a window.

Operation

Adjusting the browning level

The desired level of browning, from "light" (1) to "dark" (7), can be adjusted
infi nitely with the toasting dial 1.
STS 850 A1
3 immediately and disconnect the power cable
GB
IE
7

Publicité

Table des Matières

Dépannage

loading

Table des Matières