IARP VIC 4SK Instructions D'emploi Et D'entretien page 18

For a good preservation of the cabinet's body a periodical cleaning is necessary.
EXTERNAL BODY: When necessary, the external body should be cleaned with a cloth and a neutral
soap and water solution.
STAINLESS STEEL SURFACES: Wash with warm water and mild detergent, rinse well and dry
with soft cloth. Avoid scouring pads etc. which will spoil the finish of the stainless steel.
SURFACES IN PLASTIC MATERIAL: Wash with warm water and mild detergent, rinse well and
dry with soft cloth; under no circumstances should alcohol, methylated spirits or solvents be used.
GLASS SURFACES: Only use products specifically designed for glass cleaning; It is not advisable
to use ordinary water which can leave a film of calcium on the surface of the glass.
MALFUNCTIONS AND REMEDIES
Most of the functioning inconveniences are generally due to simple causes or to defective electrical
connections. These problems can usually be solved on site.
The unit does not start:
- check that there is voltage at the wall socket;
- check that the unit is properly plugged;
- check that there is voltage at the wall socket;
If the problem persists despite the above checks, contact your nearest service centre and empty
the unit.
The internal temperature is not cold enough:
- check that the unit is not placed too close to any heating source;
- check that there is not too much ice on the tank walls;
- check the thermostat position;
- check that the condenser is not blocked by dirt.
- check the covers closing.
If the prblem persist despite the above checks, contact your nearest service centre.
The unit is noisy:
- check that all the bolts and nuts are properly fastened;
- check that the unit is placed on an even surface;
- check if any pipe or fan is in contact with any other part of the body.
DISPOSAL
The cabinet contains oil, inflammable cooling gas, plastic and metallic components and glass .
Warning!
Polyurethane insulation uses CICLOPENTHANE as expander, that doesn't affect the environment but is
inflammable. To guarantee the same respect when it's disposed of , never abandon the equipment outside.
Don't throw the packaging material from your equipment in the rubbish but sort the various materials:
eg.polystyrene, cardboard, plastic bags.
The demolition of the cabinet and the recovery of the component materials must be carried out according
to the local regulations in force in this matter.
INFORMATIONS ABOUT SERVICE
-18-