Setting The Self-Clean Mode; To Set The Self-Clean Mode; To Change The Cleaning Time; To Delay The Start Of Cleaning - Fulgor Milano Sofia Guide D'utilisation Et D'entretien

22 - Setting the Self-Clean Mode

EN

To Set the Self-Clean Mode

1. Touch [UPPER/LOWER] key to select the cavity to be
cleaned, if the oven is a double.
2. Rotate both knobs into the clean position.
3. CLEAN & TIME appear.
4. The clean time is displayed automatically, its standard value
is 3 hours.
5. At the end of the programmed cleaning time, the oven will
automatically turn off.
6. To stop the cleaning mode at any moment, move one of the
two knobs from the cleaning position.
Do not attempt to open the door while the door is locked. The
"AUTO LOCK" writings will flash until the motor stops. When
they are displayed, the door cannot be opened. Check that
the door has been locked and will not open before starting the
Self-Clean mode.
If door does not lock, rotate the cooking mode knob into the
OFF position and do not start self-clean; phone for service. If
the door is in the open position when this mode is selected, the
"AUTO LOCK" writings will flash until the door is closed. The
latch doesn't move.

To Change the Cleaning Time

1. To change the setting from 3 hours, select either 2 hours
for light soil or 4 hours for heavy soil immediately before
starting.
2. To change the hours, touch the
3. The hours will flash.
+
-
4. Use or keys to change the value.
5. To change the minutes, touch the
6. The minutes will flash.
+
-
7. Use or keys to change the value. Hold the key to
change by 10 minutes steps.
8. Touch TIME or wait a few seconds to confirm the new
value.
26
TIME key.
TIME key again.

To Delay the Start of Cleaning

1. Follow steps 1 through 7 above.
2. Touch the TIME key and verify that "STOP TIME" appears
on the display. The hours will begin flashing.
+
-
3. Use or keys to change the stop time value.
4. To change the minutes, touch the
flash.
+
5. Use or - keys to change the value. Hold the key to
change by 10 minutes steps.
6. Touch TIME or wait a few seconds to confirm the new
value.
7. The latch starts moving to lock the oven door, the display
shows "DELAY"..
8. When the delay time expires, self-cleaning will start.
9. At the end of the programmed cleaning time, the oven will
automatically turn off.
10. "End" will appear on the temperature display, "CLEAN" on
the mode display and "TIME" on the clock display will start
flashing until the TIME key is touched or the knob is moved
to the OFF position.
In order to check the cleaning or the stop time during a
delayed clean, simply touch the
"STOP TIME" writings are displayed.
TIME key, the minutes will
TIME key until "TIME" or