EUROM VK2001 Manuel D'utilisation page 10

20. Close supervision is necessary when the product is used near children or incapacitated persons. Do not let
children use the appliance as a toy. This appliance is not suitable to be operated by children or persons who
have physical, sensory and/or mental limitations, or by persons who have no knowledge of, or experience
with, this appliance.
21. Keep the heater clean. Dust, dirt and/or a build up of deposits in the heater are a common cause of
overheating. Make sure these deposits are removed regularly.
22. Do not turn on the appliance if you have discovered damage to the appliance, cord or plug, if the appliance is
malfunctioning, if it has been dropped or if there are signs of any other defect. Return the complete product to
the vendor or to a certified electrician for inspection and/or repair. Always ask for original parts.
23. Do not use attachments and/or accessories, not recommended or supplied by the manufacturer.
24. The appliance (incl. cord and plug) may only be opened and/or repaired by properly authorised and qualified
persons.
25. Only use this heater for its intended purpose and as described in this instruction manual.
Not abiding by instructions 23, 24 and 25 may lead to damage, fire and/or personal injuries. A failure to adhere to
these rules also immediately nullifies the guarantee and vendor, importer and/or manufacturer do not take
responsibility for any of the consequences!
Description
1 – control dial
2 – thermostat dial
3 – pilot light
4 – handle
5 – air outlet grill
6 – air intake grill
Location and Connection

Remove all packaging material and keep out of reach of children. After removing packaging, check the
appliance for damage or other signs that could indicate a fault/defect/malfunction. In case of doubt, do not
use the appliance, but contact your vendor for inspection or replacement.

Choose a suitable location for the heater which is at least one metre away from any obstructions, walls or
inflammable materials (see also safety instructions). This radiator cannot be hung but must stand:
upright (on the feet) or flat (on handle and feet).

Make sure a functioning heater is always placed on a solid, flat and horizontal surface.

Check if the control dial is set to 'OFF' (O).

Fully extend the power cord and plug into a suitable 220/240V socket. To prevent the circuit overloading,
check that no other appliances are connected to the same group.
Set-up and Operation

Turn the thermostat dial to maximum (clockwise as far as possible).

Switch the heater on by turning the control dial to one of the following three positions:
Fan only (thermostat always to maximum)
●
Heating at half power (1000W)
●●
Heating at full power (2000W)
The light at the front will turn on.
It is most economical to heat the space at full power, then to switch to half power to maintain the
temperature.

Both at half and full power, the fan rotates at the same speed; the difference between the two lies in the
number of heating elements in use.

Once the desired temperature is reached, turn the thermostat dial back slowly until you hear a click. The
temperature is now set. The heater will automatically switch on and off to maintain the set temperature.
When the heater switches off, the pilot light turns off as well. To set a higher or lower temperature, turn the
thermostat dial either clockwise or anticlockwise.
10
10