Briteq BT-36II Mode D'emploi page 7

ENGLISH
DMX-CONFIGURATION OF BT-36 II:
8 channel mode
15 channel mode
BRITEQ
®
OPERATION MANUAL
9/69
ENGLISH
HOW TO OPERATE THE UNIT
Every time you turn the unit on, it will show "LedU" on the display and move all the motors to their 'home'
position and you may hear some noises for about 20 seconds. After that the unit will be ready to receive
DMX signal or run the built-in programs.
YOU CAN OPERATE THE UNIT IN FOUR WAYS:
 BY MASTER/SLAVE BUILT-IN PREPROGRAM FUNCTION:
Select this function when you want an instant show. By linking the units in master/slave connection, the
first unit will control the other units to give an automatic, sound activated, synchronized light show. Its DMX
input will have nothing plugged into it, and its master-LED will be constantly on and sound-LED will flash to
the music.
Important! This function only works when the blackout mode in the menu of the master is set to
OFF, otherwise nothing will happen! Read more about this option in the "Main Menu" paragraph.
 MASTER has 4 built-in shows: You can select
 SLAVES have 2 working options: The other units are set to slave mode (slave-LED is constantly on).
In order to create a great light show you can introduce contrast movements (pan/tilt of slave is
inversed)  In the menu of the slave units you can go to option
 BY EASY CONTROLLER
When used in Master/slave mode we strongly advice you to use the CA-8 "Easy
controller" Just connect this small controller to the 1/4" jack of the master unit, and you
will be able to control the following FUNCTIONS:
Stand By
Function
Mode
MAINTENANCE
 Make sure the area below the installation place is free from unwanted persons during servicing.
 Switch off the unit, unplug the mains cable and wait until the unit has been cooled down.
During inspection the following points should be checked:
 All screws used for installing the device and any of its parts should be tightly fastened and may not be
corroded.
 Housings, fixations and installations spots (ceiling, truss, suspensions) should be totally free from any
deformation.
 When an optical lens is visibly damaged due to cracks or deep scratches, it must be replaced.
 The mains cables must be in impeccable condition and should be replaced immediately when even a
small problem is detected.
 In order to protect the device from overheat the cooling fans (if any) and ventilation openings should be
cleaned monthly.
BT-36 II BRITEQ
By master/slave built-in preprogram function
o
By CA-8 easy controller
o
By universal DMX controller (8 & 15 channel DMX mode)
o
(show 4) directly in the menu of the master.
 Normal slave: slave works in sync with the master.
o
 2 light show: slave works in opposite with the master.
o
Blackout the unit
1. Sync. Strobe Select Show Fade Speed
2. Two-light strobe 1-4 Fast
3. Sound Strobe Middle
Slow
Sound (LED OFF) LED Normal LED ON
Blinking
10/69
®
OPERATION MANUAL
(show 1), (show 2), (show 3) or
and select:
1.Pan positioning
2.Tilt positioning
3.Dimmer or Color change
LED Fast Blinking
BT-36 II