AERMEC FCW 212V Manuel D'utilisation Et D'installation page 46

INSTALLATION Of pfw2 wIRED
CONTROL pANEL (ACCESSORy)
Accessory indispensable for the func-
tioning of the fan coil unit. Alternative
to the remote control TLw2. The two
control systems cannot be used togeth-
er.
A PFW2 wired control panel can only
control one fan coil unit.
The panel can be fixed directly to the
wall with two screws or a rectangu-
lar electrical box. The panel cable is 4
metres long and is fitted with connector
(B) for connection to the fan coil circuit
board as shown in the wiring diagrams.
To install the wired control panel it is
necessary:
- to disconnect the connector (A) of the
Terminal
cover
Display board
connections to
the front panel
Wired control panel
cable
46
IFCW3LJ 1210 - 5375700_01
infrared receiver from the circuit board
inside the fan coil unit.
- connect connector (B) of the wired
control panel to the circuit board con-
nector now vacant.
The PFW2 makes it possible to set the
operating parameters of the unit and
these parameters are shown on a liquid
crystal display, making programming
operations easier.
Avoid installing the panel in positions
where it is directly exposed to the sun
light.
Microprocessor
controller
Remove the circuit
board
Female socket
Male connector
of wired control
panel
Wired control
panel
pfw2