Liquid Crystal Display; Use Of The Remote Control - AERMEC FCW 212V Manuel D'utilisation Et D'installation

LIQUID CRySTAL DISpLAy

With the remote control on (ON), the display shows the settings of the unit, with the remote control off (OFF) the display is off
and only displays the timer for the programmed activation (if active).
1 - OpERATING MODE
Shows the operating mode:
AUTO automatic
FAN ventilation
COOL cooling
DRY dehumidification
HEAT heating
2 - fAN SpEED
Display of the three fan speeds and the automatic speed control:
AUTO automatic speed control
HIGH high speed
MED medium speed
LOW low speed
3 - HORIZONTAL BLADE pOSITION
Displays the four fixed positions of the horizontal blades and oper-
ation with the blades moving.
4 - kEy LOCk
Shows the key lock function is activate.
5 - SLEEp pROGRAMME
Shows the night comfort function SLEEP is active.
6 - TEMpERATURE (°C) OR (°f)
Displays the set point temperature value in °C or °F.
7 - TIMER
Indicates that the timer programmed on or off function has been activated.
8 - TRANSMISSION INDICATOR
Appears every time a button is pushed and it indicates the transmission of the signal.

USE Of THE REMOTE CONTROL

– Point the remote control transmitter towards the fan coil receiver while the settings
are being programmed.
– To be able to carry out any operation or change of the settings from the remote con-
trol, the unit must be powered.
– When a signal is received correctly by the FCW it will emit a beep. If you do not
hear the sound, press the remote control button again.
– Obstacles must not be placed between the transmitter and the receiver (e.g. furniture
or curtains) to ensure proper operation.
– The remote control is able to transmit effectively up to 7 metres from the fan coil unit
receiver.
pREpARATION Of THE REMOTE CONTROL
– Open the battery cover by pressing slightly in the direction of the arrow.
– Insert two 1.5 Volt high-performance alkaline batteries LR 03 (AAA), being careful not invert the polarity.
– Close the battery cover.
IMpORTANT
– The two control types, wired control panel and remote control, cannot be used at the same time on the same fan coil unit.
– The batteries have an average life of 10 months when used normally.
– The two batteries must be identical and must be changed at the same time.
– Remove the batteries from the remote control unit if you envisage the units not being used for long periods.
– When the remote control only works near the fan coil unit, it is time to replace the batteries.
– Do not fix the remote control bracket near a source of heat or in direct sunlight. Avoid exposing the remote control to exces-
sive humidity or knocks (it might break, become deformed, or lose its colour ).
– Do not place the remote control near electronic equipment because it could interfere with the unit's proper operation.
36
IFCW3LJ 1210 - 5375700_01
Œ

Ž


‘
’
“