Parker StarlettePlus-E SPS004 Manuel D'utilisation page 12

English
6 Maintenance
a) The machine is designed and built to guarantee continuous
operation; however, the life of its components depends on the
maintenance performed;
b) when requesting assistance or spare parts, identify the ma-
chine (model and serial number) by reading the data plate lo-
cated on the unit.
6.1 General instructions
!
Before any maintenance, make sure:
• the pneumatic circuit is no longer pressurized;
• the dryer is disconnected from the main power supply
Y
. Always use the Manufacturer's original spare parts: oth-
erwise the Manufacturer is relieved of all liability regarding ma-
chine malfunctioning
Y
In case of refrigerant leakage, contact qualifi ed and author-
ized personnel.
Y
The Schrader valve must only be used in case of machine
malfunction: otherwise any damage caused by incorrect refriger-
ant charging will not be covered by the warranty.
6.2 Refrigerant.
Charging: any damage caused by incorrect refrigerant replace-
ment carried out by unauthorized personnel will not be covered
Z
by the warranty.
Y
The equipment contains fl uorinated greenhouse gases.
At normal temperature and pressure, the R513A refrigerant is a
colourless gas classifi ed in SAFETY GROUP A1 - EN378 (group
2 fl uid according to Directive PED 2014/68/EU)
GWP (Global Warming Potential) = 573.
!
In case of refrigerant leakage, ventilate the room.
SPS004-SPS100
6.3 Preventive Maintenance Programme
To guarantee lasting maximum dryer effi ciency and reliability
Maintenance Maintenance Interval
Activity Description (standard operating condi-
Activity
Check Service
Check POWER ON indicator is
lit.
Check control panel indicators.
Check condensate drain.
Clean condenser fi ns.
Check electrical absorption.
Depressurize the dryer. Com-
plete drain maintenance.
Depressurize the dryer. Replace
pre- and post-fi lter elements.
The following are available (see par. 8.4):
a) compressor kits;
b) fan kits;
c) automatic expansion valve kits;
d) individual spare parts.
6.4 Dismantling
The refrigerant and the lubricating oil contained in the circuit
must be recovered in conformity with current local environmen-
tal regulations.
The refrigerant fl uid is recovered before fi nal scrapping of the
)
tions
equipment ((EU) No. 517/2014 art.8).
%
structural work
exchanger
pipes
drain
exchanger insulation
pipe insulation
compressor
condenser
refrigerant
valves
electrical cables
4 / 6
Z
Recycling Disposal
steel/epoxy-polyester resins
aluminium
aluminium/copper
polyamide
EPS (sintered polystyrene)
synthetic rubber
steel/copper/aluminium/oil
steel/copper/aluminium
R513A
brass
copper/PVC