Adjusting Trim Angle - Yamaha F115A Manuel D'utilisation

UP
UP
DN
DN
q
q
DN
UP

ADJUSTING TRIM ANGLE

EMU01401
Power Trim/Tilt Model
w
8 Be sure all people are clear of the out-
board
trim/tilt angle, also be careful not to
pinch any body parts between the drive
000350
unit and clamp bracket.
8 Use caution when trying a trim position
for the first time. Increase speed gradu-
ally and watch for any signs of instabili-
ty or control problems.
8 Use the power trim/tilt switch located
on the bottom engine cowling (if
equipped) only when the boat is at a
complete stop with the engine off.
The outboard motor trim angle can be
000351
adjusted operating the power trim/tilt
switch 1.
To raise the bow ("trim-out"), push the
switch UP.
To lower the bow ("trim-in"), push the
switch DN.
Make test runs with the trim set to differ-
ent angles to find the position that works
best for your boat and operating condi-
tions.
NOTE:
To adjust the trim angle while the boat is
moving, use the power trim and tilt
switch located on the remote control
device or tiller handle, if so equipped.
3-15
motor when adjusting
GB
the