Publicité
Les langues disponibles
Les langues disponibles
Maintenance table
Defect
Possible cause
The pump does not
1.
Too much liquid in the pump.
pump or pumps too
2.
Suction piping not sealing.
little of liquid, the
3.
Too low engine power selected.
engine runs.
4.
Suction piping input filter
clogged.
5.
Suction piping clogged.
6.
Pump moving wheel blocked by
impurities.
7.
Too high suction lift/total head.
8.
Defective slide locking ring.
9.
Pump moving wheel not fitted
correctly.
10.
Damaged pump moving wheel.
11.
Irregular engine operation.
Vibration or noisy
1. Too high suction lift/total head.
operation
2. Foreign particle blocks the suction
piping and/or the pump moving
wheel.
3. Unstable installation.
4. Unstable machine installation.
5. Damaged pump moving wheel.
6. Other technical defect.
The engine does not
1.
Low fuel.
start or turns off
2.
No ignition spark.
during operation.
3.
Clogged carburettor.
4.
Clogged air filter.
5.
Activated Auto Stop because of
low engine oil level.
6.
Other technical defect.
Remedy
1.
Pour liquid in the filling hole of the pump body.
2.
Tighten the suction piping and piping connectors with
Teflon tape. Replace the suction piping if irreparable
damage is detected.
3.
Increase engine power.
4.
Clean the filter.
5.
Clean the suction piping.
6.
Remove impurities.
7.
Change the installation so that the suction lift/total head
does not exceed maximum value.
8.
Replace the slide locking ring.
9.
Place the pump moving wheel correctly.
10.
Replace the pump moving wheel.
11.
Contact the customer service.
1.
Change the installation so that the suction lift/total head
does not exceed maximum value.
2.
Remove foreign particle.
3.
Stabilize the installation.
4.
Ensure stable position of the machine.
5.
Replace the pump moving wheel.
6.
Contact the customer service.
1.
Open the gasoline cock and/or refuel.
2.
Check the ignition switch. Or check the ignition plugs.
3.
Clean the carburettor.
4.
Clean air filter.
5.
Replenish engine oil.
6.
Contact the customer service.
Publicité
