EUROM RK1507NN Manuel D'utilisation page 12


Screw the 2 x 2 swivel castors (3) with the 4 capped nuts (2) onto the ends of the two wheel supports (1). The
wheels should be at the hollow side!

Turn the radiator upside-down (make sure you don't scratch the paint or the floor!)

Attach the two supports (each with 2 swivel castors) to the radiator. Slide the U-shaped bolts onto both sides
between the outer fins of the radiator, the end the screw thread and the outwards facing curve.

First slide the supports (with the swivel castors) over the curve and then over the end of the screw thread.
Please note: the wheels should be placed as far
away from one another as possible!

Return the heater to its upright position, wheels down.
Warning: only use the heater when it is in an upright position, with the wheels attached to the bottom (as
pictured on the front of this booklet). Any other position is dangerous!

Choose a suitable location for the heater which is at least one metre away from any obstructions, walls or
inflammable materials (see also safety instructions).

Make sure a functioning heater is always placed on a solid, flat and horizontal surface. Never place it on a bed,
couch, deep pile carpet etcetera!

Check that the socket used is earthed and that it matches the power specified on the heater's type plate.
Set-up and Operation

Set the power switches to O (off) and the thermostat dial to 5 (maximum).

Plug in the heater.

In order to switch on the heater, set one or both power switches to l.c.q. II. The light(s) on the related switch(es)
turn(s) on and the heater starts to function. For slow heating, a small rise in temperature or a small space, choose
setting I (RK1507N: 500W, RK2009N: 800W). For quick heating, a bigger temperature rise or a larger space,
choose setting II (RK1507N: 1000W, RK2009N: 1200W). I and II together give full power (RK1507N: 1500W,
RK2009N: 2000W).

Once the space has reached the right temperature, turn the thermostat dial to the left (to 0) until you hear a click. If
you leave the dial in this position, the heater will maintain the current temperature by regularly switching on and off.
When the heater is switched on, the light(s) will go on. By turning the thermostat dial to the right/left, you
increase/decrease the set temperature.

If so desired, you can now switch to a lower power level.

To switch off, turn the power switches to O (off). The heater switches off. Unplug.

Note! It takes a long time for an oil filled radiator to cool down. Give the radiator sufficient time to cool down before
touching or moving (use handle!).
12