EUROM Golden 1500 Shadow Manuel D'utilisation page 18

B. Directly attaching to the wall:
Attach the suspension bracket horizontally to the wall using the four (4)
-
cotter bolts.

Adjust the device to the required radiation angle. The radiator has three (3)
positions: straight ahead, downwards under an angle (directed far away) and
downwards under an angle (directed nearby).
Secure the device in the required position by
screwing the small screws (X) into the suspension
bracket and radiator bracket.

Fasten all screws another time firmly and scheck
or the heater is firmly mounted. Now your infra
red heater is ready for use.

For personal protection the installation, to which
the Eurom Golden Shadow is connected, has to be
equipped with an earth fall device (max. 30
mAmp).
Under some circumstances it may be attractive to
make a fast connection between the heater and the
main supply, and to operate the heater with a switch.
Because the Eurom Golden Shadow has a high water
tightness (IP65) and for safety reasons, such a connection has to be made by a
qualified electrician.
Note: The Golden Shadow is not suitable for ceiling mounting!
Working
Check for every use:
- or the appliance doesn't show signs of damage.
- or the appliance still is fastened firmly. Mechanical bearing pressure, oscillating
duet o wind or rain could lead to loose.
- or there are no objects, canvas, sun screens etc. are inside the safety distances.
- or the socket you want to use gives the correct tension (220-240V-50Hz) and is
grounded.
If everything is all right you can insert the plug into the socket.
The Golden Shadow has a remote control that works with 2 AAA batteries (not
oncluded). While using, point the remote control to the receiving point of the heater.
If there are obstacles between remote control and the heater, it will not work!
Remove the batteries out of the season, that will extend the life of the remote control.

Press the main switch (8) at the side of the device to 'I' (ON). The red indicator
light (6) light up (standby-modus).

Subsequently, press the red ON/OFF button on the remote control (X). The red
indicator light (6) turns green and the device will operate at half capacity: it hardly
diffuses light!
18