Télécharger Imprimer la page

EUROM Golden 1500 Shadow Manuel D'utilisation page 17

Masquer les pouces Voir aussi pour Golden 1500 Shadow:

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 32
Wall support
-
Remote control
-
Fastening materials
-
Installing the heater
Remove all package material, keep the packaging material out of the reach of
children and check the appliance, supply cord and the plug for signs of damage.
Attach the suspension bracket to the device. To that end, put the round parts of
the suspension bracket in between the
bracket of the device. Screw and tighten both
sides using the large screws, nuts and
washers (included in the delivery) through
the large holes (see the illustration).
Pay attention to the mounting place for your
heater. The appliance has to be mounted on
an incombustible foundation. That foundation
has to be vibrationfree, exact vertical and
stable enough for lastingly holding the
appliance free of problems.
provided (anchor bolts) are suitable, strong
enough and qualified for the foundation. The
material provided is identified for a brick wall; for another foundation please ask
the specialist for suitable material.
Check before mounting or the minimum safe mounting distances between heater
and environment are strictly followed. The distance between the bottom edge of
the appliance and the floor must be at least 1,8 meter. There must be a distance
of at least 0,5 meter between the appliance and the ceiling, roof or other cover.
There must be a distance of at least 1,5 meter at each side between the appliance
and walls or the like. When you install the appliance outside, pay attention that it
doesn't catch excessive wind load.
Attach the Golden Shadow to the wall. The Golden Shadow can be attached to the
wall in two ways:
A. Semi-permanently by means of the wall support
B. Permanently by attaching it directly to the wall
A. Attaching to the wall using the wall support:
Attach the wall support horizontally to the wall using the four (4) cotter bolts
-
included in the delivery.
Hang the terrace radiator in the wall support using the suspension bracket.
-
Slide the suspension bracket as far as possible through the wall bracket so
that the small hole in the suspension bracket winds up under the wall
support. Secure the terrace radiator by turning the wing nut (included in the
delivery) as far as possible in the small hole of the suspension bracket (see
the illustration).
Check or the
17

Publicité

loading