EUROM VK2001 Manuel D'utilisation page 27

Fan only (thermostat always to maximum)
● Heating at half power (1000W)
●● Heating at full power (2000W)
The light at the front will turn on.
It is most economical to heat the space at full power, then to switch to half
power to maintain the temperature.
 Both at half and full power, the fan rotates at the same speed; the difference
between the two lies in the number of heating elements in use.
 Once the desired temperature is reached, turn the thermostat dial back slowly
until you hear a click. The temperature is now set. The heater will automatically
switch on and off to maintain the set temperature. When the heater switches
off, the pilot light turns off as well. To set a higher or lower temperature, turn
the thermostat dial either clockwise or anticlockwise.
 To switch the heater off, set the power dial to '0' (off). The pilot light will turn
off. The pilot light, in other words, indicates that the heater is switched on, not
that the heater is connected to the mains!
 Unplug.
Safety features
In case of internal overheating, the overheating safeguard will switch the heater
off. This may occur if the heater cannot give off enough heat or if it cannot draw in
enough fresh air. As mentioned above, this is generally caused by (partially)
covering the heater, obstructing the air intake and/or outlet grills or installing the
heater too close to a wall or something similar. When the overheating safeguard
switches the heater off, set the mode selector dial to '0' (off), unplug and allow the
heater to cool down. Remove and/or amend the cause of overheating and reuse the
heater as normal. If you cannot find a cause and overheating recurs, stop using the
heater, and take it in for inspection/repair.
Cleaning and maintenance
Keep the heater clean. Deposits of dust and dirt in the appliance are a common
cause of overheating so these should be removed regularly. Switch off the heater,
remove the plug from the socket and allow the heater to cool down before cleaning
or carrying out maintenance work.
 Wipe the outside of the heater regularly with a dry or slightly damp cloth. Do
not use aggressive soaps, sprays, cleaners or abrasives, waxes, polishes or
chemical solutions!
 Using a vacuum cleaner, carefully remove any dust and dirt from the grills and
ensure that the air intake and outlet openings are clean. Be careful not to touch
or damage any internal parts during cleaning!
 The heater contains no other parts which need maintenance.
 At the end of the season, store the cleaned heater in the original packaging if
possible. Store upright in a cool, dry and dust-free place.
27