Num'axes CANICOM 700 Guide D'utilisation page 24

- The CANICOM receiver collar is totally waterproof. Your dog can swim in water.
- The remote control is showerproof only: it is only designed to remain a short time in the rain. Put it in
a dry place as soon as possible. If the remote control falls into the water, it could be damaged in an
irreversible way.
- Your dog should not wear a medal, metallic collar, or any other kind of collar together with a
CANICOM collar
- Avoid placing the remote control close to objects sensitive to magnetic fields which could be irreversibly
damaged.
- Do not place or keep the unit in places exposed to high temperatures.
- NUM'AXES advises to use the same type and same brand of batteries as those supplied in your new
purchased product. Other brands of batteries may not operate, or may not be completely compatible
with your product. You can purchase the suitable batteries from NUM'AXES or from your distributor.
- Remove the battery from the receiver collar and the remote control if you are not using the appliance
for 3 months or more. The collar will memorize the configuration chosen (coding).
- It is necessary to replace the batteries every two years, even if the unit has not been used for long periods.
- Never leave a discharged battery in the unit (remote control and collar): leakage could damage your
CANICOM 700.
Maintenance
- Avoid cleaning the unit with volatile liquids such as solvents or cleaning fluids. Use a soft cloth and
neutral detergent.
- In order to maintain water tightness, we recommend the replacement of the seal located in the receiver
collar every year.
Troubleshooting
Should your CANICOM 700 stop working or develop a fault, first read this user's guide over, then check
the batteries and replace them if necessary and retry. Also check that you are using the product correctly.
If you encounter any problem, re-code the receiver collar with the remote control (ref. coding procedure).
Re-initialise the system by removing the collar battery from its housing, then with a metallic tool (e.g.
screwdriver, scissors) touch each of the 2 battery contacts for 2 seconds approximately (ref. Diagram 7).
Insert the battery again: One beep is emitted, indicating the battery is in correct position.
Gb - 24
Diagram 7
Reset: connect
the 2 supports of
the battery