Num'axes CANICOM 700 Guide D'utilisation page 20

Gb - 20
3. Move the remote control away from the receiver collar.
4. Press the button of the remote control. A beep sound is emitted, the collar is then synchronized with
your remote control.
N Reprogram a receiver collar
Receiver can be re-coded indefinitely, either with the same remote control, or with a new CANICOM
remote control (Ref. § coding procedure).
How to use the remote control
The CANICOM 700 remote control is designed to operate with 1 receiver collar.
O
button: beeper
If you press the « Beeper » button the receiver collar will emit sound signals. There is no time limit for
this function: the beeper will continue for as long as the button is pressed.
It's up to you to use the beeper depending on the way you want to train your dog. With the beeper button
you can:
- send a sound to your dog when it is disobedient,
- draw its attention,...
It's very important to always use the beeper button in the same way in order not to disturb
your dog.
O F button: Flash stimulation
Press the «F» button to send a warning to your dog using stimulations transmitted by the two contact
points located on the receiver collar for a defined length of time of less than one second.
O C button: Continuous stimulation
Press the «C» button to send a warning to your dog using stimulations transmitted by the two contact
points located on the receiver collar, this will last for as long as the button is pressed but limited to
8 seconds maximum.
If you press the «C» button for more than 8 seconds, the collar will automatically go into safety mode for
a few seconds before restarting itself normally.
O « Booster » button
Press the Booster button to stop your dog instantaneously. You can choose the stimulation level you
think to be the best for an immediate effect. As a result, you do not need to press the « + » button.
Those stimulations are transmitted by the two contact points located on the collar for as a long as
the button is pressed but no more than 8 seconds max.
If you press the « Booster » button for more than 8 seconds, the collar will automatically go into
safety mode for a few seconds before restarting itself normally.