Num'axes CANICOM 700 Guide D'utilisation page 21

« Booster » button configuration:
- select the stimulation level 01
- press the "-" button until the stimulation level flashes on the LCD screen
- press the "+" or "-" button to modify the stimulation level
- press the « Booster » button to confirm the level selected
O « + » and « - » : stimulation level control buttons
Use the "+"/"-" buttons for rapid adjustment of the stimulation level of the receiver collar.
15 levels are available.
Level 1: very weak stimulation. Level 15: strong stimulation.
Always start with the lowest level of stimulation.
O Retro-lightning of the LCD screen
You can light the LCD screen for approximately 6 seconds by pressing briefly the On/off switch ( ).
Checking/replacing battery of remote control
Performance (radio range) of the remote control may deteriorate as battery becomes weak. Be
prepared to replace the battery.
To check the condition of the battery, turn on the remote control and look at the battery level indicator
on the LCD screen.
Battery fully charged.
Weak battery: prepare to replace the battery.
Dead battery: your CANICOM 700 functions
in safety mode and the system locks up.
The battery must be replaced.
Remove the old battery and replace it with a new one :
- On the back of the remote control, unscrew the screw
and remove the battery cover.
- Remove the old battery.
- Insert the new battery (3-V lithium CR 2) paying attention
to follow polarity indicated on the battery housing.
(ref. Diagram 6).
- Put the battery cover back in place.
- Retighten the screw.
- Check the remote control operates correctly.
Gb - 21
Diagram. 6
Replacing battery
of CANICOM 700
WARNING
Make sure the polarity is correct