Num'axes CANICOM 700 Guide D'utilisation page 19

- Activate: approach the area where the On/Off switch magnet is located inside the remote control until
coming in contact on white indicator located on the receiver collar, hold for 1 second (ref. Diagram 5),
the indicator light on the collar will flash in green indicating that the collar is On.
- Deactivate: approach the area where the On/Off switch magnet is located inside the remote control until
coming in contact on white indicator located on the receiver collar, hold for 1 second (ref. Diagram 5),
the indicator light will flash from green to red and then off: the collar is off.
To increase the battery life of the receiver collar, we recommend you deactivate the unit if you are no longer
using your CANICOM 700 for a long period.
Diagram 5
Activate/Deactivate a receiver
collar with a CANICOM 700
remote control
N Coding of the remote control and receiver collar
Each remote control has its own individual radio operator code. The coding of the remote control with the
receiver collar enables the two units to work together.
IMPORTANT: before beginning the coding, make sure no other person is using his CANICOM 700
or other products from the NUM'AXES range close by: your receiver collar could accidentally
record the code of his remote control. If that occurs, re-code the remote control with the receiver collar.
CODING PROCEDURE
1. Activate the remote control: press for 1 second the On/Off red button ( ) located on the side of the
remote control.
2. Receiver collar in position « deactivated » (indicator off): approach the area where the On/Off
switch magnet is located in the remote control until coming in contact on white indicator located on the
receiver collar, hold for 6 seconds. The indicator lights in fixed green, then flashes in red.
Gb - 19
Approach until coming in
contact those 2 areas
during 1 second
COLLAR
REMOTE CONTROL