Undoing The Last Edit (Undo Function) - Sony MDS-JA30ES Mode D'emploi

Editing Recorded MDs
Erasing all titles on a disc (Name All Erase)
Use this function to erase all titles on an MD
simultaneously.
1
While the deck is stopped, press EDIT/NO.
2
Turn AMS until "Name ?" appears in the display
and press AMS.
3
Turn AMS until "Nm All Ers ?" appears in the
display and press AMS.
"Nm All Ers??" appears in the display.
4
Press AMS.
"Complete!!" appears for a few seconds and the all
the titles is erased.
To cancel the Name All Erase Function
Press p.
z
You can undo the Name All Erase Function
See "Undoing the Last Edit" on this page.
z
You can erase all recorded tracks and titles
See "Erasing all tracks on an MD" on page 30.
Undoing the Last Edit (Undo
Function)
You can use the Undo Function to cancel the last edit
and restore the contents of the MD to the condition that
existed before editing was done. Note, however, that
you cannot undo an edit if you do any of the following
after the edit:
• Press the r REC button on the deck.
• Press the r button, the MUSIC SYNC button, or the
CD SYNC STANDBY button on the remote.
• Update the TOC by turning off the power or ejecting
the MD.
• Disconnect the AC power cord or set the MAIN
POWER switch on the rear panel to OFF (only on
European model).
POWER
g
TIMER
REC OFF PLAY
INPUT FILTER
PHONES PHONE LEVEL OPT1
OPT2 • COAX
ANALOG
PLAY MODE REPEAT
0 10
36 EN
≠ AMS ±
EDIT/NO
≠
EDIT/
NO YES
0 )
PUSH ENTER
SCROLL/ DISPLAY/
CLOCK SET CHAR
§
TIME
OPEN/CLOSE
1
With the deck stopped and no track number
appearing in the display, press EDIT/NO and turn
AMS until "Undo ?" appears in the display.
"Undo ?" does not appear if no editing has been
done.
2
Press AMS.
One of the following messages appears in the
display, depending on the type of editing to be
undone:
Editing done:
Erasing a single track
Erasing all tracks on an MD
Erasing a part of a track
Dividing a track
Combining tracks
Moving a track
Labeling a track or an MD
Changing an existing title
Erasing all titles on an MD
Copying a title
3
Press AMS again.
"Complete!!" appears for a few seconds and the
contents of the MD are restored to the condition
that existed before the edit.
To cancel the Undo Function
Press EDIT/NO or p.
±
AMS DIGITAL REC LEVEL ANALOG
0 5
4 6
3 7
2 8
1 9
– + 0 10
L R
( P p r
REC
Message:
"Erase Undo ?"
"Divide Undo ?"
"CombinUndo ?"
"Move Undo ?"
"Name Undo ?"