Getting Started - Sartorius Miras 2 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

Getting Started

Storage and Shipping Conditions
Do not expose the scale to shocks,
vibrations, moisture or extreme temper-
atures.
Unpacking the Scale
After unpacking the scale, check it
immediately for any visible damage as a
result of rough handling during ship-
ment.
Note:
– The display and control unit is attached
to the weighing platform via a cable.
– If you see any sign of damage, proceed
as directed in the chapter entitled "Care
and Maintenance," under the section on
"Safety Inspection."
– Save the box and all parts of the pack-
aging until you have successfully
installed your scale. Only the original
packaging provides the best protection
for shipment. Before packing your scale,
unplug all connected cables to prevent
damage.
Equipment Supplied
The equipment supplied includes the
components listed below:
– Scale with attached display and control
unit
– Load pan
– Installation and operating instructions
Installation Instructions
The Sartorius Miras scales are designed
to provide reliable weighing results
under normal ambient conditions.
When choosing a location to set up
your scale, observe the following so that
you will be able to work with added
speed and accuracy:
– Set up the scale on a stable, even sur-
face
– Avoid placing the scale in close proximi-
ty to a heater or otherwise exposing the
scale to heat or direct sunlight
– Protect the scale from drafts that come
from open windows or doors
– Avoid exposing the scale to extreme
vibrations during weighing
– Protect the scale from aggressive
chemical vapors
– Do not expose the scale to extreme
moisture over long periods
– Remove transport locking: see page 9
Conditioning the Scale
Moisture in the air can condense on the
surfaces of a cold scale whenever it is
brought into a substantially warmer
place. If you transfer the scale to a
warmer area, make sure to condition it
for about 2 hours at room temperature,
leaving it unplugged from AC power.
Afterwards, keep the scale continuously
connected to AC power.
7 7

Publicité

Table des Matières
loading

Table des Matières