6 .2
Configuring the panels
If several panels are installed configuration is required.
6 .3
Place the panel in configuration mode
N.B. The panel must be in the OFF position (if the panel is NOT in the
OFF position, first press the On / Off button once to switch the panel
to the OFF position.
• Press and hold the On / Off button for 10 seconds.
During the first 6 seconds, the buzzer will continuously signal a didi-
didididi ..... (. . . .). Keep pressing the On / Off button. After 10 seconds
the buzzer sounds the signal dididididah (. . . - -). Now the panel is in
configuration mode.
6 .4
Configuring a panel for operating a bow thruster or a stern thruster
1
2
Place the
panel in
configuration
mode, see 6.3.
2
didahdi ( . − . )
6 .5
Configuring a panel for the steering position where the panel is placed
1
2
Place the
panel in
configuration
mode, see 6.3.
2
didahdi ( . − . )
With a bow and stern thruster panel, together at the same helm station, the helm station number entered must be the same .
vetus® Installation instructions BOW PRO Series Thrusters: BOWA0361 and BOWA0421
3
1
3
1
The illustrated operations must be performed on EACH panel in-
stalled .
10 seconds
4
1 x
BLUE
4
OR
Helm station
1
2
3
4
1 BLUE, ashing
2 RED, ashing
3 BLUE, ashing
RED, quick ashing
4 BLUE and RED,
simultaneously ashing
n
ote
ENGLISH
6 seconds
dididididididid ( . . . . . . )
3 seconds
dididididah ( . . . . − )
Con guration mode
5
1 x
1 x
RED
5
Helm station
2
1
3
4
1 x
020803.01
31