EUROM EK3201 Manuel D'utilisation page 27

capacity of the device and will nullify the guarantee and the
manufacturer's liability.
5. If the electrical cable is damaged, it must be replaced by the
manufacturer, their service department or somebody with similar
qualifications in order to prevent creating a hazard.
Failing to adhere to points 3, 4, 5, could lead to damage, fire and/or
personal injury. They will invalidate the guarantee and the supplier,
importer and/or manufacturer shall not be liable for the consequences.
Description
EUROM EK heaters are 'real space' heaters, with a powerful fan which disseminates
a great deal of air. Cold air is sucked in at the back, heated, and then blown out as
hot air. Because a relatively large quantity of air is sucked in and blown out, the air
expelled by the heater does not feel particularly hot. As a great deal of air is heated
and blown out, however, the entire space (not just the air around the heater!) is
gradually warmed up.
Control panel
The EK3201 control panel consists of two dials:
 The mode selector dial with 4 positions is located on the left.
From top to bottom:
 The continuously adjustable thermostat dial is located on the right.
Location and Connection
 Remove all packaging material and keep out of reach of children. After removing
packaging, check the appliance for damage or other signs that could indicate a
fault/defect/malfunction. In case of doubt, do not use the appliance, but contact
your vendor for inspection or replacement.
- O or off
- 1000W power
- 2000W power
- 3000W power
27