EUROM EK3201 Manuel D'utilisation page 24

10. The base on which the device is placed must not be made of
flammable materials. It must be resistant to temperatures of at
least 125°C without burning, melting, deforming or bursting into
flames. Check regularly to ensure that the surface is not
overheating; this could be dangerous!
11. Never place the device on surfaces such as beds or deep-pile carpet
as openings could be blocked.
12. Do not place the device near an open window as rain could blow in;
do not place on wet surfaces and avoid any liquids being spilt
nearby. Do not place the device behind a door or along a walking
route to avoid accidental trips.
Warnings – use
1. Do not use additions/accessories on the device that have not been
supplied or approved by the manufacturer.
2. Only use the device for its intended purpose and in the manner set
out in this instruction leaflet.
3. Some parts of this device will get very hot and could cause
burns. You must pay particular attention to children,
vulnerable persons and pets that are present near the
device. Never leave them alone with a working device.
4. Never cover or block the device; it will overheat and this could lead
to a fire risk. Never hang or place objects such as clothing,
blankets, cushions, paper, etc. on the device. The minimum
distance of 1 metre between the device and flammable materials
must always be applied. Ventilation openings should never be
blocked as this may pose a fire risk. Never use the device to dry
clothing or place anything on it. Do not let anything lean against the
device!
5. Do not set the device to come on automatically using a timer, clock
or other facility. You must always check for safe conditions before
using the fireplace! Never use the device with an external voltage
regulator such as a dimmer or similar, as this could be dangerous!
6. This device is exclusively intended to be used for heating
workplaces such as workshops, garages, storage spaces, etc. You
must only use the device for this purpose.
7. The connection voltage and frequency, as given on the device, must
correspond to that of the socket to be used. The electrical socket to
be used must be an earthed connection. The electrical installation
must be protected via a 30 mA earth leakage circuit breaker. The
24