EUROM EK2K Round Manuel D'utilisation page 30

fault/defect/malfunction. In case of doubt, do not use the appliance, but contact
your vendor for inspection or replacement.
Select a suitable location for the device taking into account all the

aforementioned warnings in this manual.
Make sure the heater is switched off (switch to O position), then plug into a

correctly functioning, properly grounded socket.
Set-up and Operation
If the heater is being used for the first time (or if you want to reset the desired

temperature), turn the thermostat dial to the maximum position (clockwise as
far as it goes).
With the mode selector dial, adjust the heater to suit your preferences: fan only,

low power or high power.
Once the temperature in the area being heated has reached the right level,

slowly turn the thermostat dial anticlockwise until you hear a soft click; leave the
dial in that position. The heater will automatically maintain the temperature at
this level. It does this by switching the heating elements off and on when the
temperature rises or falls too much.
Note! After the thermostat has switched the heating elements off, the fan will

keep turning. This means that the air is constantly moved, allowing the heater to
accurately detect if the area is cooling down.
The thermostat dial is continuously adjustable. A higher temperature is set by

turning it clockwise; a lower temperature by turning it anticlockwise.
Safety features
In case of internal overheating, the overheating safeguard will switch the heater off.
If this occurs, immediately turn the mode selector dial to O, unplug and allow heater
to cool down for at least 10 minutes. In theory, the heater can now be used as
normal. There is, however, generally a reason for an appliance overheating. This may
be because the heater cannot adequately release its heat or take in fresh air (because
the heater is covered, the grills are blocked, the heater is placed too near a wall
etcetera). Before using the heater again, therefore, remove or adjust whatever
caused the appliance to overheat. If you cannot find the cause and overheating
recurs, stop using the heater and contact your vendor or a certified electrician for
inspection/repair. Overheating poses a serious fire risk!
Cleaning and maintenance
Keep the heater clean. Deposits of dust and dirt in the appliance are a common
cause of overheating so these should be removed regularly. Switch off the heater,
remove the plug from the socket and allow the heater to cool down before cleaning
or carrying out maintenance work..
30