EUROM EK2K Round Manuel D'utilisation page 29

4. The device may only be opened and/or repaired by a competent
and qualified person. Do not carry our your own repairs as this
could be dangerous! Repairs carried out by unauthorised persons or
changes made to the device could damage the dust/waterproof
capacity of the device and will nullify the guarantee and the
manufacturer's liability.
5. If the electrical cable is damaged, it must be replaced by the
manufacturer, their service department or somebody with similar
qualifications in order to prevent creating a hazard.
Failing to adhere to points 3, 4, 5, could lead to damage, fire and/or
personal injury. They will invalidate the guarantee and the supplier,
importer and/or manufacturer shall not be liable for the consequences.
Description
1. Handle
2. Control panel
thermostat dial
3. Air outlet
4. Adjustment knobs
5. Frame
By loosening the adjustment knobs (4), the heater
can be tilted in its frame so that the blow direction can
be adjusted. Do not point it downwards onto flammable or heat sensitive floors! For
safety reasons, the tilt is limited. Re-tighten the knobs before using the heater again!
Control panel
The control panel consists of
two dials:
 The mode selector dial with
3 positions is located on the
left:
- O or off
- fan and 1000W power
- fan and 200W power
 The continuously adjustable
thermostat dial is located on
the right.
Location and Connection
Remove all packaging material and keep out of reach of children. After removing

packaging, check the appliance for damage or other signs that could indicate a
with mode selector dial and
29