Safety Guidelines For Battery Chargers; Before Use; Charging The Battery Pack (See Fig. A) - Parkside Performance PSBSAP 20-Li A1 Traduction Des Instructions D'origine

Perceuse visseuse à percussion sans fil
Masquer les pouces Voir aussi pour PSBSAP 20-Li A1:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 35
Safety guidelines for battery
chargers
This tool may be used by children
aged 8 years and above and by
persons with limited physical, sensory
or mental capabilities or lack of ex-
perience and knowledge, provided
that they are under supervision or
have been told how to use the tool
safely and are aware of the poten-
tial risks. Do not allow children to
use the tool as a toy. Cleaning and
user maintenance tasks may not be
carried out by children unless they
are supervised.
To avoid potential risks, damaged
mains cables should be replaced
by the manufacturer, their customer
service department or a similarly
qualified person.
The charger is suitable
for indoor use only.
WARNING!
To avoid potential risks, damaged mains cables
should be replaced by the manufacturer, their
customer service department or a similarly
qualified person.
ATTENTION!
This charger can only charge the following
batteries: PAP 20 A1/PAP 20 A2/PAP 20 A3.
A current list of battery compatibility can be
found at www.Lidl.de/Akku.
PSBSAP 20-Li A1

Before use

Charging the battery pack
(see fig. A)
CAUTION!
Always unplug the tool before you remove
the battery pack from or connect the battery
pack to the charger.
NOTE
Never charge the battery pack if the ambient
temperature is below 10°C or above 40°C.
If a lithium-ion battery is going to be stored
for an extended period, the charge level
should be checked regularly. The optimum
charge level is between 50% and 80%. The
storage climate should be cool and dry and
the ambient temperature should be between
0°C and 50°C.
Connect the battery pack 
charger
(see fig. A).
Insert the power plug into the socket. The red
charge control LED
The green charge control LED
that the charging process is complete and the
battery pack 
is ready for use.
ATTENTION!
If the red charge control LED 
this means that the battery pack 
overheated and cannot be charged.
If the red and green charge control LEDs  /
both flash, this means that the battery
pack 
is defective.
Push the battery pack 
Switch off the charger for at least 15 minutes
between successive charging sessions. Also
disconnect the power plug from the mains
power socket.
to the high-speed
lights up red.
indicates
flashes,
has
back into the tool.
GB │ IE
 │
 23

Publicité

Table des Matières
loading

Table des Matières