Inserting/Removing The Battery Pack; Checking The Battery Charge Level; Additional Handle; Depth Stop - Parkside Performance PSBSAP 20-Li A1 Traduction Des Instructions D'origine

Perceuse visseuse à percussion sans fil
Masquer les pouces Voir aussi pour PSBSAP 20-Li A1:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 35

Inserting/removing the battery pack

Inserting the battery pack
Set the rotation direction switch 
position (lock). Push the battery pack 
the handle until it clicks into place.
Removing the battery pack
Press the release button 
battery pack  .

Checking the battery charge level

Press the battery charge level button 
check the status of the battery (see the main
diagram). The status/remaining charge will be
shown on the battery display LED 
RED/ORANGE/GREEN = maximum charge
RED/ORANGE = medium charge
RED = low charge – charge the battery

Additional handle

NOTE
For safety reasons, you should never use
this tool without the additional handle 
attached.
Loosen the strap on the additional handle 
by turning it clockwise.
Slide the mounting ring for the additional
handle 
over the chuck  .
Turn the additional handle 
position.
Afterwards, twist the additional handle 
anticlockwise again to tighten it.
24
GB │ IE
to the middle
into
and remove the
to
as follows:
to the required

Depth stop

Push the locking button for the depth stop 
and keep it pushed in.
Fit the depth stop 
handle  .
Make sure that the teeth on the depth stop 
point upwards and downwards.
Pull the depth stop 
between the tip of the drill and the tip of the
depth stop corresponds with the required
drilling depth.
Release the locking button for the depth stop 
to lock the depth stop 

Changing tools

Your cordless impact drill driver has a fully auto-
matic spindle lock
When the motor is stopped, the power train is
locked so that the chuck 
turning
. After you have attached the desired
tool and tightened it by turning the chuck
can continue working. The spindle lock is released
automatically when the motor is started (by pressing
the ON/OFF switch  ).
Torque selection/selecting the
operating mode
You can set the torque using the torque selection
ring 
or by choosing between the drill setting
and the hammer drill setting
Select a low level for small screws or soft
materials.
Select a high level for large screws, hard
materials or removing screws.
Select the drill setting for drilling work by adjusting
the torque selection ring to the position .
Select the hammer drill setting for hammer drilling
work by adjusting the torque selection ring to
the position
.
into the additional
out until the distance
in place.
.
can be opened by
, you
.
PSBSAP 20-Li A1

Publicité

Table des Matières
loading

Table des Matières