2-Speed Gearbox; Operation; Switching On/Off; Setting The Rotational Speed - Parkside Performance PSBSAP 20-Li A1 Traduction Des Instructions D'origine

2-speed gearbox

CAUTION!
► Operate the speed selector switch
when the tool is at a standstill. Otherwise,
the tool could be damaged.
In first gear
(speed selector switch
you can reach a speed of approx. 400 rpm and a
high torque. This setting is suitable for all screwing
work.
In second gear
(speed selector switch
you can reach a speed of approx. 2000 rpm for
carrying out drilling work.

Operation

Switching on/off
Turn on
♦ Press and hold the ON/OFF switch
the tool. The LED work light
the ON/OFF switch
fully. This provides illumination of the work
area in poor lighting conditions.
Switching off
♦ Release the ON/OFF switch
the tool.

Setting the rotational speed

Pressing the ON/OFF switch
speed. Increasing the pressure increases the speed.
NOTE
► The integrated motor brake ensures that the
tool stops quickly.
PSBSAP 20-Li A1
only
in position 1),
in position 2),
to start
lights up when
is pressed lightly or
to switch off
lightly yields a low

Changing the direction of rotation

♦ Change the direction of rotation by pushing the
rotation direction switch

Tips and tricks

Tip! How to do things correctly.
♦ Before operation, check whether the screw
or drill bit is correctly fitted, i.e. centred in the
chuck.
♦ Screw bits are labelled according to their di-
mensions and their shape. If you are uncertain,
always check first whether the bit fits tightly in
the screw head without any play.
Torque
♦ Smaller screws/bits can be damaged if you
set too high a torque or too high a speed.
Hard screw joints (in metal)
♦ Particularly high torques occur, e.g. in metal
screw joints when using drive sockets. Select
a low rotational speed.
Soft screw joints (e.g. in soft wood)
♦ Here, too, use a low speed to avoid damaging
the wood surface when it comes into contact
with the metal screw head. Use a countersink.
Small screws can be screwed directly into soft
wood without predrilling.
When drilling in wood, metal and other
materials, observe the following:
♦ Use a high speed for drill bits with a small
diameter and a low speed for drill bits with
a large diameter.
♦ Select a low speed for hard materials and
a high speed for soft materials.
♦ Mark the spot where you want to drill using
a centre punch or nail. Select a low rotational
speed when starting.
♦ Pull the rotating drill bit from the hole repeatedly
to remove dust and chips and clear the hole.
to the right or left.
GB │ IE │
25 ■