Siemens TE 803 Série Mode D'emploi page 23

Before starting the respective service
programme (descaling, cleaning or
calc'nClean), remove the brewing unit,
clean as instructed and replace.
Specially developed and suitable descal-
ing and cleaning tablets are available
from retailers or customer service.
Accessories Ordering number
Retail
Cleaning TZ60001 310575
tablets
Descaling TZ60002 310967
tablets
Cleaning the milk system
Duration: approx. 1 minute
Cleaning and service
Short rinse
milk system
calc'nClean
The milk system 10 can be pre-cleaned
automatically.
à
button 3.
● Press the
Short rinse milk system
● Press the start button 8.
Place glass under frother, place
suction pipe in glass
● Place an empty glass under the milk
system 10 and put the end of the pipe
10d in the glass.
● Press the start button 8. The milk system
is cleaned automatically.
● Now empty the glass and clean the
suction pipe 10d.
In addition to this, clean the milk system
thoroughly at regular intervals (by hand or
in the dishwasher).
TE803_806_1RW.indb 19
Customer
service
start

start

start

Descaling
Duration: approx. 30 minutes.
Cleaning and service
Descale
Clean
The start button 8 flashes while the different
descaling processes are running.
The figures on the top right indicate the
progress of the programme.
Important: If there is a water filter in the
water tank 11, it needs to be removed
before the service programme is run.
à
● Press the button 3.
Descale start

● Press the start button 8; the display 5 will
guide you through the programme.
Empty drip tray
Replace drip tray
● Empty the drip tray 23 and reinsert it.
Place 1 l container
Place suction pipe in container
● Place a container with 1 litre capacity
under the milk frother 10.
● Place the end of the suction pipe 10d in
the container.
● Press the start button 8.
Remove filter start

Info: If the water filter is activated, the dis-
play will prompt you to remove the filter,
then press the start button 8 again.
en
start

start

19
08.05.2013 14:24:14