NEFF T16TS7KN Série Notice D'utilisation page 64

Home Connect
en
Symbol Function
Signal strength 3 (good)
„
Connection to Home Connect server
•'‰
Not connected.
‹
Connected.
‚
* Basic setting
Notes
The setting is only displayed if the appliance is
•'ƒ
■
connected to the home network.
The setting is only displayed if the appliance
•'„
■
has once connected to a network.
The setting is only displayed if an update is
•'†
■
available.
The setting is only displayed if Customer
•'‡
■
Service is attempting to connect to the appliance.
You can end this at any time after granting access.
The and
•'ˆ •'‰
■
there is a connection to WLAN.
Deactivating WLAN
If Wi-Fi has been activated, you can use the Home
Connect functions.
Note: In networked standby mode, your appliance
requires a maximum of 2 W.
Touch the symbol for 4 seconds.
U
1.
The product information will be displayed.
Touch the symbol repeatedly until the
U
2.
setting appears.
•'„
will be lit on the hotplate display.
‚
Set the value to using the twist knob.
‹
3.
This deactivates Wi-Fi; the
control panel.
Disconnecting from the network
Y ou can disconnect your hob from the network at any
D i s c o n n e c t i n g f r o m t h e n e t w o r k
time.
Note: If your hob is disconnected from the network, it is
not possible to operate it using Home Connect.
Touch the symbol for 4 seconds.
U
1.
The product information will be displayed.
Touch the symbol repeatedly until the
U
2.
setting appears.
•'‚
will be lit on the hotplate display.
„
Set the value to using the twist knob.
‹
3.
This disconnects the appliance from your home
network; the symbol will go out on the control panel.
D
64
settings are only displayed if
D symbol will go out on the
Connecting to the network
Touch the symbol for 4 seconds.
U
1 .
C o n n e c t i n g t o t h e n e t w o r k
The product information will be displayed.
Touch the symbol repeatedly until the
U
2.
setting appears.
•'‚
‹ will be lit on the hotplate display.
Using the twist knob,
3.
set the value , "Connect automatically", or
‚
the value ƒ , "Connect manually".
Follow the instructions in the section entitled
4.
"Automatic login to your home network" or
"Manually logging into your home network".
Connect to the app
If the Home Connect app is installed on your mobile
device, you can connect it to your hob.
Notes
The appliance must be connected to the network.
■
The app must be open and be set up.
■
If your extractor hood is directly connected, first
■
disconnect the hob from your home network and
then initiate the connection process
again.~ "Disconnecting from the network"
on page 64
Touch the U symbol for 4 seconds.
1.
The product information will be displayed.
Touch the U symbol repeatedly until the
2.
setting appears.
•'ƒ
will be lit on the hotplate display.
‹
Set the value to using the twist knob.
‚
3.
Follow the instructions in the app to complete the
4.
connection process.