Tips For Saving Energy - Proline PCI223-F1-LED Mode D'emploi

Masquer les pouces Voir aussi pour PCI223-F1-LED:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Recommendations
• The compressor protection thermal fuse will cutout after sudden power breakdowns or
after unplugging the appliance, because the gas in the cooling system is not stabilised.
This is quite normal, and the fridge will restart after 4 or 5 minutes.
• The cooling unit of your refrigerator is hidden in the rear wall. Therefore, water droplets or
icing may occur on the rear surface of your fridge due to the operation of the compressor
in specified intervals. This is normal. There is no need to perform a defrosting operation
unless the icing is excessive.
• If the problem persists after you have followed all the instructions above, please consult
the nearest authorised service.
• The appliance you have purchased is designed for domestic use and can be used only
at home and for the stated purposes. It is not suitable for commercial or common use. If
the consumer uses the appliance in a way that does not comply with these features, we
emphasise that the producer and the dealer shall not be responsible for any repair and
failure within the guarantee period.

Tips for saving energy

1– Install the appliance in a cool, well-ventilated room , but not in direct sunlight or near
any heat source (radiator, cooker.. etc). Otherwise use an insulating plate.
2– Allow warm food and drinks to cool down outside the appliance.
3– When thawing frozen food, place it in the refrigerator compartment. The low
temperature of the frozen food will help to cool the refrigerator compartment when it is
thawing, thus saving energy.
4– When placing drinks and soups, make sure they are covered. Otherwise humidity
increases in the appliance, extending the time needed to reach optimum performance.
Also covering drinks and soups helps to save smell and taste.
5– When placing food and drinks, open the appliance door as briefly as possible.
6– Do not move the shelves within the appliance so as to keep the appropriate cooling
zones.
7– Door gasket must be clean and pliable. Replace gaskets if worn.
EN - 13 -

Publicité

Table des Matières
loading

Table des Matières