Before Installing And Operating Your Appliance - Proline PCI223-F1-LED Mode D'emploi

Before installing and operating your appliance

Before starting to use your fridge, you should pay attention to the following points:
• Operating voltage for your fridge is 220-240 V at 50Hz.
• The plug must be accessible after installation.
• Your appliance may have a smell when it is operated for the first time; the smell will fade
away when your appliance starts to cool.
• Before making the connection to the power supply, ensure that the voltage on the rating
label corresponds to the voltage of electrical system in your home.
• Insert the plug into a socket with an efficient ground connection. If the socket has no
ground contact or the plug does not match, please call an authorised electrician for
assistance.
• The appliance must be connected with a properly installed fused socket. Power supply
(AC) and voltage at the operating point must correspond to the details stated on the
rating label of the appliance (located on the inside left of the appliance).
• We do not take responsibility for damages that may occur as a result of usage without
grounding.
• Place your fridge in a place where it is not exposed to direct sunlight.
• Your fridge should never be used outdoors or left under the rain.
• Your appliance should be at least 50 cm away from stoves, gas ovens and heater cores,
and should be at least 5 cm away from electrical ovens.
• Do not place heavy items on the appliance.
• Clean the appliance thoroughly, especially in the interior, before use (See Cleaning and
Maintenance).
• The installation procedure into the kitchen unit is given in the Installation Manual. This
product is intended to be used in proper kitchen units only.
• The adjustable front legs should be adjusted to an appropriate height to allow your
appliance to operate in a stable and proper way. You can adjust the legs by turning
them clockwise (or counter-clockwise). This should be done before placing food in the
appliance.
• Before using your fridge, wipe all parts with warm water and one
teaspoon of sodium bicarbonate, and then rinse with clean water
and dry. Place all parts after cleaning.
• Install the distance adjustment spacer (the part with white vanes
at the rear) by turning it 90° as shown in the figure to prevent the
condenser from touching the wall.
Note:
• When it is operated for the first time or after transportation, keep your fridge in the upright
position for 3 hours before you plug it in. Otherwise, you may damage the compressor.
EN - 4 -